jcb JS300 Service Manual page 361

3.1. EGR valve
3.2. EGR cooler
4. Thermal reactor system
4.1. Exhaust manifold
4.2. Diesel oxidation catalyst (build within DPD)
5. Particulate controls
5.1. Particulate filter (build within DPD)
5.2. Diesel oxidation catalyst
6. PCV (Positive Crankcase Ventilation) system
7. Miscellaneous items used in above systems
7.1. ECT (Engine Coolant temperature) sensor
7.2. Intake manifold temperature sensor
7.3. Boost pressure sensor
7.4. Barometric pressure sensor
7.5. IAT (Intake Air Temperature) sensor
7.6. MAF (Mass Air Flow) sensor
7.7. Exhaust Gas Temperature Sensor (in front of DOC)
7.8. Exhaust Gas Temperature Sensor (behind of DOC)
7.9. Engine speed sensor (Ne)
7.10.Differential pressure sensor
7.11. Common rail pressure sensor
7.12.Cylinder detection sensor
7.13.Fuel temperature sensor
7.14.Engine control module
7.15.Turbo controller
7.16.Emission control label
If failure of one of these components results in failure of another part. both will be covered by this warranty.
Any replacement part may be used for maintenance or repairs. The owner should ensure that such parts are
equivalent in design and durability to, lsuzu genuine parts.
Use of non-genuine lsuzu parts does not invalidate the warranty. However Isuzu Motors America LLC is not
liable for parts, Which are not genuine Isuzu parts.
Imitations and Responsibilities
These warranties are subject to the following:
Isuzu Motors America LLC Responsibilities
During the emission warranty period, if a defect in material or workmanship of a warranted part or component
is found, Isuzu Motors America LLC will provide:
• New, re-manufactured, or repaired parts and/or components required to correct the defect.
• Items replaced under this warranty become the property of Isuzu Motors America LLC.
• Labour, during normal working hours, required to make the warranty repair.
286 9831/1100-2
Technical Data
Warranty Information
286