jcb JS300 Service Manual page 98

Operation
Operating Safety
Sparks
Explosions and fire can be caused by sparks from the exhaust or the electrical system. Do not use the machine
in closed areas where there is flammable material, vapour or dust.
Hazardous Atmospheres
This machine is designed for use in normal out door atmospheric conditions. It must not be used in an
enclosed area without adequate ventilation. Do not use the machine in a potentially explosive atmosphere, i.e.
combustible vapours, gas or dust, without first consulting your JCB dealer.
Regulations
Obey all laws, worksite and local regulations which affect you and your machine.
Electrical Power Cables
You could be electrocuted or badly burned if you get the machine or its attachments too close to electrical
power cables.
You are strongly advised to make sure that the safety arrangements on site comply with the local laws and
regulations concerning work near electric power lines.
Before you start using the machine, check with your electricity supplier if there are any buried power cables
on the site.
There is a minimum clearance required for working beneath overhead power cables. You must obtain details
from your local electricity supplier.
Working Platform
Using the machine as a working platform is hazardous. You can fall off and be killed or injured. Never use the
machine as a working platform unless with approved man-basket or man-crate (if applicable).
Machine Safety
Stop work at once if a fault develops. Abnormal sounds and smells can be signs of trouble. Examine and repair
before resuming work.
Hot Components
Touching hot surfaces can burn skin. The engine and machine components will be hot after the unit has been
running. Allow the engine and components to cool before servicing the unit.
Travelling at High Speeds
Travelling at high speeds can cause accidents. Do not reverse in a high gear with full throttle. Always travel
at a safe speed to suit working conditions.
Hillsides
Operating the machine on hillsides can be dangerous if the correct precautions are not taken. Ground conditions
can be changed by rain, snow, ice etc. Check the site carefully. When applicable, keep all attachments low
to the ground.
Visibility
Accidents can be caused by working in poor visibility. Use your lights to improve visibility. Keep the road lights,
windows and mirrors clean.
Do not operate the machine if you cannot see clearly.
Modification of the machine's configuration by the user (e.g. the fitting of large and non-approved attachments)
may result in a restriction of the machine visibility.
Hands and Feet
Keep your hands and feet inside the machine.
When using the machine, keep your hands and feet clear of moving parts. Keep your hands and feet within
the operator compartment while the vehicle is in motion.
Controls
You or others can be killed or seriously injured if you operate the control levers from outside the machine.
Operate the control levers only when you are correctly seated.
23 9831/1100-2 23