Travel Speed Selector - jcb JS300 Service Manual

To turn the machine to the right, push the left travel lever forwards.
To turn the machine to the left, push the right travel lever forwards.
If the travel speed selector is set to fast speed and the travel levers are operated quickly, the machine will start
quickly. Refer to: Operation > Drive Controls > Travel Speed Selector (Page 62).
The simultaneous movement of the left and right travel levers, moved in the opposite directions will cause the
machine to turn around its centre.
To move the machine backwards in a straight line pull both levers in a backwards motion equally. Both tracks
will operate in a reverse direction.

Travel Speed Selector

A Travel speed change button
The travel speed of the machine can be changed between fast, creep and slow. (The travel speed is recorded
when the engine is shut-down and the travel speed is re-applied at the next engine start-up).
Each press of the travel speed change button selects as follows: Fast, Slow, Creep, Slow, Fast, Slow, Creep
etc. Dependant on the machine software installed it may be necessary to press and hold the travel speed
change button for 1.5s to select creep speed.
62
Figure 51.
Figure 52.
AUTO
n/min
n/min
H+
9831/1100-2
Operation
Drive Controls
A
62