Drain Filter - jcb JS300 Service Manual

Replace
1 Prepare the machine.
Maintenance, Maintenance Positions.
2 Release tank pressure. Refer to Section 2,
Maintenance, Hydraulic System.
3 Get access to the
Points ( T E-296)
4 Unscrew and remove filter A from head B.
5 Fit the new filter. Coat the seal of the new filter with
clean hydraulic oil. Screw the new filter into head B
and tighten.
6 Start the engine and run it for five minutes without
load. Slowly operate the rams several times and then
check the hydraulic oil level. Refer to Section 2,
Maintenance, Hydraulic System.
Fig 7.
E-302

Drain Filter

Refer to Section 2,
K Service
drain filter.
JS02830-C1
9813/5100-1
Section E - Hydraulics
Routine Maintenance Procedures
Drain Filter
E-302