Stopping And Parking; General - jcb JS300 Service Manual

General

Stopping and Parking

DANGER Before lowering the attachments to the ground, make sure that the machine and the area around
it are clear of other people. Anyone on or close to the machine could fall and be crushed by the attachments,
or get caught in the linkages.
CAUTION Entering or leaving the operator station must only be made where steps and handrails are
provided. Always face the machine when entering and leaving. Make sure the step(s), handrails and your
boot soles are clean and dry. Do not jump from the machine. Do not use the machine controls as handholds,
use the handrails.
1. Stop the machine.
Refer to: Operation > Drive Controls > Track Controls (Page 61).
2. Align the upper structure and undercarriage to allow you to use the handrails and steps.
3. Lower the attachment.
Refer to: Operation > Operating Levers/Pedals > Excavator Arm Controls (Page 96).
4. If applicable, lower the dozer blade.
Before you stop the engine, run it at idle speed for 30s, to let the turbocharger cool down.
1. Stop the engine.
1.1. Press the controls isolation switch.
Refer to: Operation > Locks > Control Lock (Page 59).
1.2. Turn the ignition key to the 0 position.
0
1
2
3
2. If you are going to leave the machine, remove the ignition key and make sure that all unnecessary switches
are set to off.
3. Leave and secure the machine:
3.1. Lift the controls isolation lever.
Refer to: Operation > Locks > Control Lock (Page 59).
3.2. If you are leaving the machine for a long period, close and latch the window(s) and lock the door.
3.3. Use the handrails and steps to leave the cab.
Refer to: Operation > Entering and Leaving the Operator Station > General (Page 28).
3.4. Make sure that the fuel filler cap is locked (if a lock is installed).
56
Stopping and Parking
Ignition off/engine stop position
Ignition on position
Not used
Start position
Figure 44.
0
1
2
3
9831/1100-2
Operation
Stopping and Parking
56