jcb JS300 Service Manual page 245

Guard 7, Front top panel - position A
Hook the guard onto the rail above the front window, make sure the top lip of the guard is correctly installed
on the rail.
Guard 6, Front bottom panel - position B
Attach to the guard 7 and lock onto the two locking points on the cab front.
Guard 1, Door front panel - position C
Make sure that the cut-out on the top of the guard aligns with the marker on the rail, then install the guard
onto the roof rail.
Lock onto the locking points on the guard 7 and the cab side.
Guard 5, Door rear panel - position D
Put the top of the guard onto the roof rail and over the edge of the guard 1. Lock onto the locking point on
the side of the machine.
Guards 3 and 4, Boom side panels - position E and F
Open the guards and using the handle on top of the guard 3 slide onto the roof rail.
Do not lock the guard 3 to the locking point on the guard 7 until the guard 2 has been installed.
Guard 2, Rear window panel - position G
Install the guard with the cut-outs uppermost and lock to the four locking points on the guards 5 and 4.
Lock onto the guard 5 first.
Removing the Guards
Use the key provided to unlock and remove the guards in the reverse order of installation.
Storing the Guards
The guards are numbered and can only be stored in the order and orientation shown below. The arrows on the
guards should point towards the front of the cab when they are stowed.
Close and lock the cage.
1
2
3
4
5
6
7
170
Table 8. Guards
Guard 1 - number up
Guard 2 - number up
Guard 3 - number up
Guard 4 - number up
Guard 5 - number down
Guard 6 - number up
Guard 7 - number down
9831/1100-2
Preservation and Storage
Security
170