jcb JS300 Service Manual page 861

5 Knock out the pivot pin using a bar and hammer.
!M
WARNING
Metal Splinters
You can be injured by flying metal splinters when
driving metal pins in or out. Use a soft faced hammer
or copper pin to remove and fit metal pins. Always
wear safety glasses.
INT-3-1-3_2
Fig 50.
6 Fully retract the ram and secure the eye end of the
ram piston rod to the ram cylinder to prevent the
piston rod from extending.
Fig 51.
7 Disconnect the hoses and install plugs and caps to
prevent contamination. Discard the `O' ring seal.
E-200
8 Remove the pivot pin retaining nuts and bolt from the
cylinder end of the ram. Knock out the pin using a bar
and hammer. Lower the ram clear.
You can be injured by flying metal splinters when
driving metal pins in or out. Use a soft faced hammer
JS07260-C1
or copper pin to remove and fit metal pins. Always
wear safety glasses.
INT-3-1-3_2
JS07270-C1
9813/5100-1
Section E - Hydraulics
Hydraulic Rams
Removal and Replacement
Fig 52.
!M
WARNING
Metal Splinters
JS07290-C1
Fig 53.
JS07280-C1
E-200