Immobiliser - jcb JS300 Service Manual

Immobiliser

Introduction
If your machine has an immobiliser system installed, then your JCB dealer must enable the system as part of
the standard machine installation.
Coded Immobiliser System
Introduction
Before you try to disarm the immobiliser, make sure that the machine is ready to start and that you have your
four digit security code available.
If you are unsure of the security code, then do not start this procedure. If the security code is incorrectly entered
five times the immobiliser will lock. 15min.
If this occurs, it is recommended that you contact the machine owner for confirmation of the security code.
The security code must be entered every time that the ignition key is in the off position for more than the time
specified. 2min.
Disarm the Immobiliser
1. Put the ignition key in the ignition switch.
2. Turn the ignition key to the on position.
3. Push the rotary control.
Refer to: Operation > Instruments > General (Page 64).
4. Turn the rotary control left or right to display the first digit.
5. Repeat for digits 2 to 4.
6. Push rotary control button to finalize the security code entry.
7. If the correct security code is entered, a grey unlocked padlock is displayed momentarily and the machine
can be started.
53
Figure 41.
9831/1100-2
Operation
Starting the Engine
53