jcb JS300 Service Manual page 407

Fig 6.
2 After checking for size, remove the new glass and
place it on a purpose
K Fig 7. ( T
B-38).
Fig 7. Glass Stand
Small panes of glass will need locating on a 600 x 700
mm x 15 to 19 mm thick plywood board, sourced
locally to fit the glass stand.
recommended that an access hole is cut in the board
to accommodate the glass lifter, making it easier and
safer to handle small panes of glass. The board
should be covered with felt or carpet to give an anti-
scratch surface. Resting the glass on four spacer
blocks will ensure clearance of the cartridge nozzle
tip during application of the polyurethane sealant.
B-38
made glass stand.
K Fig 8. ( T
B-38). It is
9813/5100-1
Section B - Body and Framework
Fig 8.
3 Make sure the glass is positioned on the stand the
correct way up (i.e. with the black ceramic ink band
upwards) ready for application of primer etc.
4 Clean the glass
a Use 'Active Wipe 205' to thoroughly clean and
'prime' the black ceramic ink band printed on the
glass (see Note). Use a lint free cloth to apply the
'Active Wipe 205', allow 5 minutes flash off
(drying) time.
Note: Do not touch the glass after cleaning with the 'Active
Wipe 205'.
b If the glass does not have a black ceramic ink
band, paint a band on the glass using 'Black
Primer 206J'. The band should be approximately
25mm (1in) wide, and the edge should be a neat
K Fig 9. ( T
straight line.
Fig 9.
5 Install the Ultra Fast Adhesive cartridge (see Sealing
and Retaining Compounds, Section 1 and Note)
into a suitable applicator gun:
Cab
Cab Structure
B-38).
B-38