jcb JS300 Service Manual page 220

A Fuel filler cap
Fuel Level
The amount of fuel in the tank is shown on the fuel gauge. Be alert for the red warning indicator on the gauge.
Refer to: Operation > Instruments > General (Page 64).
You should fill the tank at the earliest opportunity when the red warning indicator comes on.
Refuelling Pump
The refuelling pump will not function when the engine is running.
1. Remove the fuel filler cap to let the air escape.
2. Remove the fuel hose from the securing clips and the support.
3. Make sure the suction end of the fuel hose is clean and open the close-off valve. If dirty, use a small
container of fuel to clean the suction end.
4. Put the suction end of the fuel hose into the fuel container.
5. Push the switch to select Auto mode or Manual mode.
6. Auto Mode:
6.1. To start the pump, push the switch once for less than:
Duration: 2s
6.2. Push the switch again to stop the pump.
6.3. The pump will automatically stop when the level gauge reaches the tank capacity. To fill the tank fully,
use Manual mode.
7. Manual Mode:
7.1. Push and hold the switch until the required amount of fuel is pumped into the tank.
8. Remove the fuel hose from the fuel container.
9. Tighten the close-off valve down.
10. Stow the hose.
11. Replace the filler cap.
145
Figure 180.
A
9831/1100-2
Operation
Refuelling
145