Toyota AVENSIS 2000 Supplement Manual page 753

AC–14
AVENSIS/CORONA SUP (RM781E)
AIR CONDITIONING – COMPRESSOR AND MAGNETIC CLUTCH
INSTALLATION
1. 1ZZ–FE, 3ZZ–FE Engines:
INSTALL COMPRESSOR
(a) Install the compressor with 3 bolts.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
(b) Connect the connector.
I13000
2. 1AZ–FSE Engine:
INSTALL COMPRESSOR
(a) Install the compressor with 4 bolts.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
(b) Connect the connector.
3. CONNECT DISCHARGE AND SUCTION HOSES
(a) Lubricate 2 new O–rings with compressor oil and install
them to the hoses.
(b) Connect the both hoses with 2 bolts.
Torque: 10 N·m (100 kgf·cm, 7 ft·lbf)
NOTICE:
Hose should be connected immediately after the caps have
been removed.
I12999
4. INSTALL AND CHECK DRIVE BELT (See page
AC–2, AC–4)
5. CONNECT NEGATIVE (–) TERMINAL CABLE TO BAT-
TERY
6. EVACUATE AIR FROM REFRIGERATION SYSTEM
CHARGE SYSTEM WITH REFRIGERANT
Specified amount: 460 ± 20 g (16.23 ± 0.71 oz.)
7. INSPECT FOR LEAKAGE OF REFRIGERANT
Using a gas leak detector, check for leakage of refrigerant.
If there is leakage, check the tightening torque at the joints.
8. INSPECT A/C OPERATION
AC39H–01