Toyota AVENSIS 2000 Supplement Manual page 261

DI–130
Ts
DLC3
CG
0.13 secs.
ON
OFF
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
BR3890
F04969
0.12 secs.
BR3904
– ANTI–LOCK BRAKE SYSTEM WITH ELECTRONIC
BRAKE FORCE DISTRIBUTION (EBD)
(d) Clear the DTC.
(1) Using SST, connect terminals Tc and CG of DLC3.
SST 09843 – 18040
(2) Turn the ignition switch ON.
(3) Clear the DTC stored in ECU by depressing the
brake pedal 8 or more times within 3 seconds.
(4) Check that the warning light shows the normal
code.
(5) Remove the SST from the terminals of DLC3.
SST 09843 – 18040
HINT:
Cancellation cannot be done by removing the battery cable or
ECU–IG fuse.
2. SPEED SENSOR SIGNAL
(a) Check the speed sensor signal.
(1) When the ignition switch is turned ON, check that
the ABS warning light goes on for 3 seconds.
(2) Turn the ignition switch OFF.
(3) Using SST, connect terminals Ts and CG of DLC3.
SST 09843 – 18040
(4) Start the engine.
(5) Check that the ABS warning light blinks.
HINT:
If the ABS warning light does not blink, inspect the ABS warning
light circuit (See page DI–159).
(6) Drive vehicle straight forward.
Drive vehicle at 45 – 55 km/h (28 – 34 mph) for sev-
eral seconds.
HINT:
If the brake is applied during the check, the check routine must
be started again.
(7) Stop the vehicle.
(8) Turn the ignition switch OFF.
(9) Disconnect the SST from terminals Ts and CG, and
connect the SST to terminals Tc and CG of DLC3.
SST 09843 – 18040
(10) Turn the ignition switch ON.