Toyota AVENSIS 2000 Supplement Manual page 141

DI–10
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
Q02281
(f)
If not as started above, carry out the following adjustment pro-
Neutral
cedures:
Basic Line
Groove
Q02284
HINT:
For continuity inspection of the neutral start switch, see page
DI–45.
– AUTOMATIC TRANSAXLE (A246E)
(3) Return the control shaft lever 2 notches to the N
range.
(4) Set the shift lever to N range.
(5) While holding the shift lever lightly toward the R
range side, tighten the shift lever nut.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
(6) Start the engine and make sure that the vehicle
moves forward when shifting the lever from the N to
D range and reveres when shifting it to the R range.
Inspect and adjustment the neutral start switch.
Check that the engine can be started with the shift lever
only in the N or P range, but not in other ranges.
(1) Loosen the neutral start switch bolt and set the shift
lever to the N range.
(2) Align the groove and the neutral basic line.
(3) Holding the shift selector, and tighten the bolt.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)