Toyota AVENSIS 2000 Supplement Manual page 438

Align Alignment Mark
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (C50, C250)
25.
Remove the 2 bolts and reverse shift arm bracket.
NOTICE:
At the time of reassembly, please refer to the following
items.
D07336
26.
(a)
(b)
Q05789
(c)
NOTICE:
At the time of reassembly, please refer to the following
item.
To avoid the interference of the 2 balls, lift up the No. 3 gear
shift fork shaft at the position shown in the illustration.
D03039
– MANUAL TRANSAXLE ASSEMBLY
REMOVE REVERSE SHIFT ARM BRACKET
Torque: 17 N·m (175 kgf·cm, 13 ft·lbf)
S
Set the pin on the top of the reverse shift arm into a
groove on the reverse idler gear.
S
Fit the claw of the reverse shift arm bracket with the
notch of the input shaft front bearing.
S
Install the reverse idler gear, thrust washer and shaft,
as shown in the illustration.
REMOVE GEAR SHIFT FORK AND GEAR SHIFT FORK
SHAFT
Using 2 screwdrivers and a hammer, tap out the 3 snap
rings from each gear shift fork shaft.
Remove the 3 bolts from the No. 1 gear shift head, No. 1
and No. 2 gear shift forks.
Sealant:
Part No. 08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 16 N·m (160 kgf·cm, 12 ft·lbf)
Pull up the No. 3 gear shift fork shaft, remove the No. 2
gear shift fork shaft.
MX–17