Toyota AVENSIS 2000 Supplement Manual page 645

Hide thumbs Also See for AVENSIS 2000:

Table of Contents

AVENSIS/CORONA SUP (RM781E)

SUSPENSION AND AXLE

(3.27 – 3.31 in.)

FRONT DRIVE SHAFT

RH drive shaft of 1ZZ–FE and 1AZ–FSE engine:

ASSEMBLE INBOARD JOINT SHAFT

Using a pin punch and hammer, install the straight pin into

the bearing case.

Using SST and a press, install a new bearing into the

bearing case.

09950–60010 (09951–00640), 09950–70010

(09951–07150)

Using a screwdriver, install a new snap ring.

Using SST and a press, install the bearing case assembly

to the inboard joint shaft.

09710–30021 (09710–03141)

Using a snap ring expander, install a new snap ring.

Using SST, an extension bar and press, install a new dust

INSTALL NEW DUST COVER

RH drive shaft of 3ZZ–FE engine:

Using a steel plate and press, install a new dust cover until

the distance from the tip of center drive shaft to the dust

cover reaches the specification, as shown in the illustra-

Show Quick Links

Chapters

Table of Contents