Toyota AVENSIS 2000 Supplement Manual page 140

Add if hot
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
(c)
F00483
Z13623
OK if hot
NOTICE:
Do not overfill.
(d)
AT3417
If there are leaks, it is necessary to repair or replace O–rings,
FIPGs, oil seals, plugs or other parts.
(e)
If the indicator is not aligned with the correct range, carry out the
following adjustment procedures:
Q08545
– AUTOMATIC TRANSAXLE (A246E)
Replace the ATF.
(1) Remove the drain plug and drain the fluid.
(2) Reinstall the drain plug securely.
(3) With the engine OFF add new fluid through the oil
filler pipe.
Fluid type: ATF Type D–II or DEXRON®III (DEXRON®II)
Capacity: 3.1 liters (3.3 US qts, 2.7 Imp.qts)
(4) Start the engine and shift the shift lever into all
ranges from P to L range and then shift into P range.
(5) With the engine idling, check the fluid level. Add
fluid up to the COOL level on the dipstick.
(6) Check the fluid level at the normal operating tem-
perature, 70 – 80 °C (158 – 176 °F), and add as
necessary.
Check the fluid leaks.
Check for leaks in the transaxle.
Inspect and adjust the shift lever range.
When shifting the shift lever from the N range to the other
range, check that the lever can be shifted smoothly and
accurately to each range and that the range indicator cor-
rectly indicates the range.
(1) Loosen the nut the control shaft lever.
(2) Push the control shaft lever fully downward.
DI–9