Toyota AVENSIS 2000 Supplement Manual page 200

N
R
P
Bolt
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
D07260
(f)
Neutral Basic
Line
If it is not as stated above, carry out the following adjustment
procedures.
Bolt
Groove
D07257
HINT:
For continuity inspection of the neutral start switch, see page
DI–112.
– AUTOMATIC TRANSAXLE (U240E)
(3) Return the control shaft lever 2 notches to N range.
(4) Set the shift lever to N range.
(5) While holding the shift lever lightly toward the R
range side, tighten the shift lever nut.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf)
(6) Start the engine and make sure that the vehicle
moves forward when shifting the lever from the N to
D range and reverses when shifting it to the R
range.
Inspect and adjust the neutral start switch.
Check that the engine can be started with the shift lever
only in the N or P range, but not in other ranges.
(1) Loosen the neutral start switch bolt and set the shift
lever to the N range.
(2) Align the groove and the neutral basic line.
(3) Holding the shift selector, and tighten the bolt.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
DI–69