Toyota AVENSIS 2000 Supplement Manual page 503

MX–34
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (E351)
REASSEMBLY
HINT:
Coat all of the sliding and rotating surfaces with gear oil before
reassembly.
1.
(a)
(b)
HINT:
Front
Direct identification groove of the hub sleeve to the front of the
transmission.
Q06204
2.
Using SST and a press, install the 1st gear bearing inner race.
HINT:
Align the hole of the output shaft and inner race.
Align the holes
SST
Q06205
3.
(a)
(b)
(c)
D08965
(d)
4.
SST
Q06206
– OUTPUT SHAFT
INSTALL NO.1 CLUTCH HUB INTO HUB SLEEVE
Install the 3 springs and shifting keys to the clutch hub.
Install the hub sleeve to the clutch hub.
INSTALL 1ST GEAR BEARING INNER RACE
SST 09506–35010
INSTALL NEEDLE ROLLER BEARING, 1ST GEAR,
SYNCHRONIZER RING AND NO.1 HUB SLEEVE TO
OUTPUT SHAFT
Apply MP grease to the needle roller bearing.
Install the 1st gear.
Place the synchronizer ring (for the 1st gear) on the gear
and align the ring slots with the shifting keys.
Using SST and a press, install the 1st gear and No.1 hub
sleeve.
SST 09316–60011 (09316–00041)
MEASURE 1ST GEAR THRUST CLEARANCE
(See page MX–30)
MX02F–07