Toyota AVENSIS 2000 Supplement Manual page 646

AVENSIS/CORONA SUP (RM781E)
SUSPENSION AND AXLE
(b)
A
F02277
3.
Vinyl Tape
HINT:
S
S
W01994
(a)
(b)
(c)
4.
(a)
(b)
(c)
(d)
NOTICE:
Do not tap the roller.
(e)
– FRONT DRIVE SHAFT
RH drive shaft of 1ZZ–FE and 1AZ–FSE engine:
Using a steel plate and press, install a new dust cover until
the distance from the tip of center drive shaft to the dust
cover reaches the specification, as shown in the illustra-
tion.
A:
1ZZ–FE Engine M/T:
86 – 87 mm (3.39 – 3.43 in.)
1ZZ–FE Engine A/T:
83 – 84 mm (3.27 – 3.31 in.)
1AZ–FSE Engine:
87 – 88 mm (3.43 – 3.46 in.)
TEMPORARILY INSTALL NEW OUTBOARD AND IN-
BOARD JOINT BOOTS WITH NEW BOOT CLAMPS
Before installing the boots (and dynamic damper), wrap
the spline of the outboard joint shaft with vinyl tape to pre-
vent them from being damaged.
Before installing the boots (and dynamic damper), place
new clamps to each of them and then install boots to drive
shaft.
Temporarily install a new outboard joint boot with 2
clamps to the drive shaft.
w/ Dynamic damper:
Temporarily install the dynamic damper with clamp to the
drive shaft.
Temporarily install a new inboard joint boot with 2 clamps
to the drive shaft.
INSTALL TRIPOD
Using a snap ring expander, install a new snap ring.
Place the beveled side of the tripod axial spline toward the
outboard joint.
Align the matchmarks placed before removal.
Using a brass bar and hammer, tap in the tripod to the
drive shaft.
Using a snap ring expander, install a new snap ring.
SA–9