Toyota AVENSIS 2000 Supplement Manual page 513

MX–44
SST
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (E351)
5.
NOTICE:
Perform this only when replacing the tapered roller bearing
and outer race of the differential case.
(a)
(b)
CM0061
(c)
(d)
D09380
If the preload is not within the specification, remove the trans-
mission case side outer race of the tapered roller bearing with
SST (See page MX–39). Select an appropriate shim.
Mark
0
1
2
3
4
5
6
7
8
(e)
(f)
– DIFFERENTIAL CASE
INSPECT DIFFERENTIAL TAPERED ROLLER BEAR-
ING PRELOAD
Install the differential case assembly to the transaxle
case.
Install the transmission case to the transaxle case with
the 17 bolts.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
Using SST and a torque wrench, turn the differential case
assembly right and left 2 or 3 times to allow the bearings
to settle.
SST 09564–32011
Using SST and a torque wrench, measure the preload.
SST 09564–32011
Preload (at starting):
New bearing
0.8 – 1.6 N·m (8 – 16 kgf·cm, 6.9 – 13.9 in.·lbf)
Reused bearing
0.5 – 1.0 N·m (5 – 10 kgf·cm, 4.3 – 8.7 in.·lbf)
Thickness mm (in.)
2.00 (0.0787)
2.05 (0.0807)
2.10 (0.0827)
2.15 (0.0846)
2.20 (0.0866)
2.25 (0.0886)
2.30 (0.0906)
2.35 (0.0925)
2.40 (0.0945)
Remove the 17 bolts and transmission case.
Remove the differential case assembly.
Mark Thickness mm (in.)
9 2.45 (0.0965)
A 2.50 (0.0984)
B 2.55 (0.1004)
C 2.60 (0.1024)
D 2.65 (0.1043)
E 2.70 (0.1063)
F 2.75 (0.1083)
G 2.80 (0.1102)
H 2.85 (0.1122)