Toyota AVENSIS 2000 Supplement Manual page 182

3 Check OVERDRIVE CUT SW2 signal.
ON
(–)
NG
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
When using hand–held tester:
PREPARATION:
(a)
(b)
CHECK:
Read the OVERDRIVE CUT SW2 signal on the hand–held tes-
ter.
OK:
When not using hand–held tester:
PREPARATION:
Turn the ignition switch ON.
CHECK:
Check voltage between the terminal OD2 of Engine and ECT
ECU and the body ground.
OK:
OD2
(+)
D07199
– AUTOMATIC TRANSAXLE (A246E)
Connect a hand–held tester to the DLC3.
Turn the ignition switch ON and the hand–held tester
main switch ON.
O/D main switch condition
O/D ON (Pushed in)
O/D OFF (Pushed once again)
O/D main switch
ON
OFF
OK Check and replace the Engine and ECT ECU
(See page IN–30).
OVERDRIVE CUT SW2 signal
OFF
ON
Voltage
Below 3 V
9 – 14
DI–51