AX–22
Shift Lever
Sub–assembly
Detent Rod
Grooved Pin
A00452
: Apply MP Grease
AVENSIS/CORONA SUP (RM781E)
AUTOMATIC TRANSAXLE (U240E)
A
F01188
A
D04313
F00690
F00691
F00692
–
FLOOR SHIFT ASSEMBLY (LHD)
(f)
Press the pin with a hammer.
A: 10.0 – 10.4 mm (0.39 – 0.41 in.)
NOTICE:
When pressing in the grooved pin, if doing it at the place
other than the notch, the shift lever sub–assembly might be
damaged.
4.
CHECK DETENT ROD OPERATION
5.
INSTALL SHIFT LEVER KNOB SLEEVE DETENT ROD
Drive the shift lever knob sleeve to the distance A measured be-
fore removal.
6.
INSTALL SHIFT LEVER SUB–ASSEMBLY
(a)
Apply MP grease.
(b)
Using a brass bar and a hammer, install the control shaft
and the shift lever sub–assembly to the shift lever plate.
NOTICE:
Take care not to install them in the wrong direction of the
shift lever sub–assembly.
7.
INSTALL SPRING PLATE
8.
INSTALL SHIFT LOCK CONTROL COMPUTER
Install the shift control control computer and 2 screws.
NOTICE:
Install the grooved pin into the groove of the shift lock unit
as shown in the illustration.