Toyota AVENSIS 2000 Supplement Manual page 424

MANUAL TRANSAXLE (C50, C250)
AVENSIS/CORONA SUP (RM781E)
REMOVAL
1.
2.
(a)
(b)
D02142
3.
Remove the bolt and engine wire clamp from the transaxle.
4.
D02143
5.
Remove the set bolt and disconnect the ground cable from the
transaxle.
6.
(a)
(b)
(c)
D02144
7.
Remove the set bolt of the starter from the transaxle upper side.
8.
Starter Set Bolt
D02145
– MANUAL TRANSAXLE UNIT
REMOVE BATTERY AND AIR CLEANER CASE AS-
SEMBLY WITH AIR HOSE
DISCONNECT CLUTCH RELEASE CYLINDER AND
LINE
Remove the set bolt of the clutch line bracket.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
Remove the 2 bolts and disconnect the clutch release cyl-
inder and line.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
DISCONNECT ENGINE WIRE FROM CLAMP
DISCONNECT BACK–UP LIGHT SWITCH AND SPEED
SENSOR CONNECTORS
DISCONNECT GROUND CABLE
DISCONNECT CONTROL CABLE
Remove the 2 clips and washers.
Remove the 2 clips from the cables.
Disconnect the 2 control cables from the transaxle.
REMOVE STARTER SET BOLT
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
REMOVE 3 TRANSAXLE UPPER SIDE MOUNTING
BOLTS
Torque: 64 N·m (650 kgf·cm, 47 ft·lbf)
MX–3
MX0CZ–01