AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (C50, C250)
DISASSEMBLY
1.
HINT:
At the time of reassembly, please refer to the following item.
Apply molybdenum disulphide lithium base grease.
(See page CL–12)
2.
3.
4.
Remove the 2 bolts and control cable bracket.
5.
Remove the 2 nuts, wave washer and control shaft assembly.
D07393
6.
(a)
NOTICE:
At the time of reassembly, please refer to the following
item.
Fit the selecting bellcrank assembly pin part with the dust
cover into a groove in the control shift lever.
(b)
D07394
NOTICE:
At the time of reassembly, please refer to the following
item.
Apply MP grease to the inside circumferential surface of
the control bellcrank dust cover.
–
MANUAL TRANSAXLE ASSEMBLY
REMOVE RELEASE FORK AND BEARING
REMOVE BOLT AND SPEED SENSOR
Torque: 11 N·m (115 kgf·cm, 8 ft·lbf)
REMOVE BACK–UP LIGHT SWITCH
Torque: 40 N·m (410 kgf·cm, 30 ft·lbf)
REMOVE CONTROL CABLE BRACKET
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
REMOVE CONTROL SHAFT ASSEMBLY
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
REMOVE SELECTING BELLCRANK ASSEMBLY
Remove the 2 bolts and selecting bellcrank assembly.
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
Remove the control bellcrank dust cover from the select-
ing bellcrank assembly.
MX–11
MX0D0–01