Toyota AVENSIS 2000 Supplement Manual page 647

SA–10
RH Drive shaft of 1ZZ–FE and 1AZ–FSE
3ZZ–FE
AVENSIS/CORONA SUP (RM781E)
SUSPENSION AND AXLE
5. INSTALL BOOT TO OUTBOARD JOINT
Before assembling the boot, pack the outboard joint shaft and
boot with grease in the boot kit.
Grease capacity: (Color = Black)
85 – 105 g (3.00 – 3.70 oz.)
6. INSTALL INBOARD JOINT SHAFT TO OUTBOARD
JOINT SHAFT
(a) Pack the inboard joint shaft and boot with grease in the
boot kit.
Grease capacity: (Color = Yellow)
1ZZ–FE engine:
140 – 150 g (4.94 – 5.29 oz.)
3ZZ–FE engine:
125.5 – 135.5 g (4.43 – 4.78 oz.)
1AZ–FSE engine:
120 – 130 g (4.23 – 4.59 oz.)
(b) Align the matchmarks placed before removal.
(c) Install the inboard joint shaft to the outboard joint shaft.
(d) Temporarily install the boot to the inboard joint shaft.
7. ASSEMBLE BOOT CLAMPS TO BOTH BOOTS
(a) Make sure that the 2 boots are on the shaft groove.
(b) Make sure that the 2 boots are not stretched or contracted
when the drive shaft is at standard length.
Drive shaft standard length:
1ZZ–FE engine M/T:
F02726
1ZZ–FE engine A/T:
3ZZ–FE engine:
1AZ–FSE engine:
(c) Secure the clamps onto the boot.
(d) Place SST onto the clamps.
SST
(e) Tighten the SST so that the clamps are pinched.
NOTICE:
Do not overtighten the SST.
(f) Using SST, adjust the clearance of the clamps.
SST
Clearance: 1.9 mm (0.075 in.) or less
SST
R10353
– FRONT DRIVE SHAFT
943.60 ± 1.0 mm (37.15 ± 0.039 in.)
RH
657.90 ± 0.8 mm (25.90 ± 0.032 in.)
LH
943.60 ± 1.0 mm (37.15 ± 0.039 in.)
RH
653.20 ± 0.8 mm (25.72 ± 0.032 in.)
LH
944.70 ± 0.8 mm (37.19 ± 0.032 in.)
RH
655.70 ± 0.8 mm (25.82 ± 0.032 in.)
LH
922.65 ± 1.0 mm (36.32 ± 0.039 in.)
RH
650.85 ± 0.7 mm (25.62 ± 0.028 in.)
LH
09521–24010
09240–00020