Toyota AVENSIS 2000 Supplement Manual page 434

Removal Installation
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (C50, C250)
9.
(a)
NOTICE:
At the time of reassembly, please refer to the following
item.
Set the claws of the shift interlock plate into the shift head
part of the gear shift fork shaft securely.
(b)
D07398
10.
(a)
FIPG
(b)
Q07840
11.
(a)
(b)
(c)
(d)
Q05783
12.
(a)
(b)
HINT:
SST At the time of reassembly, please refer to the following item.
Using SST and a hammer, drive in the No.3 hub sleeve with the
shift fork.
Q05825
NOTICE:
At the time of installation, please refer to the following item.
Align the synchronizer ring slots with the shifting keys.
– MANUAL TRANSAXLE ASSEMBLY
REMOVE SHIFT AND SELECT LEVER SHAFT AS-
SEMBLY
Remove the shift and select lever shaft assembly.
Remove the select spring seat and compression spring
from the shift and select lever shaft assembly.
REMOVE TRANSMISSION CASE COVER
Remove the 9 bolts.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
Using a brass bar and hammer, carefully tap the projec-
tion of the transmission case cover to remove the trans-
mission case cover from the transmission case.
FIPG:
Part No. 08826–00090, THREE BOND 1281 or equiva-
lent
REMOVE LOCK NUT
Engage the gear to the double meshing.
Using a chisel and hammer, loosen the staked part of the
nut.
Remove the lock nut.
Torque: 118 N·m (1,200 kgf·cm, 87 ft·lbf)
Disengage the gear double meshing.
REMOVE NO.3 HUB SLEEVE AND NO.3 SHIFT FORK
Remove the bolt from the No.3 shift fork.
Torque: 16 N·m (160 kgf·cm, 12 ft·lbf)
Remove the No.3 hub sleeve with the shift fork.
SST 09636–20010
MX–13