Toyota AVENSIS 2000 Supplement Manual page 682

Vane Pump Shaft
Height
Length
AVENSIS/CORONA SUP (RM781E)
STEERING
Bushing
Front Housing
F09875
Thickness
N00372
Feeler Gauge
R10282
– POWER STEERING VANE PUMP (1AZ–FSE)
INSPECTION
1. MEASURE OIL CLEARANCE BETWEEN VANE PUMP
SHAFT AND BUSHING
Using a micrometer and a caliper gauge, measure the oil clear-
ance.
Standard clearance:
0.021 – 0.043 mm (0.0008 – 0.0017 in.)
Maximum clearance: 0.07 mm (0.0028 in.)
If it is more than the maximum, replace the front housing and
vane pump shaft.
2. INSPECT VANE PUMP ROTOR AND VANE PLATES
(a) Using a micrometer, measure the height, thickness and
length of the 10 vane plates.
Minimum height: 7.6 mm (0.299 in.)
Minimum thickness: 1.405 mm (0.0553 in.)
Minimum length: 11.993 mm (0.4722 in.)
(b) Using a feeler gauge, measure the clearance between
the vane pump rotor groove and vane plate.
Maximum clearance: 0.03 mm (0.0012 in.)
SR–23
SR0VT–08