SR–10
Drive Belt
Tensioner Arm
SST
AVENSIS/CORONA SUP (RM781E)
STEERING
–
POWER STEERING VANE PUMP (1ZZ–FE, 3ZZ–FE)
REMOVAL
1.
REMOVE ENGINE UNDER COVER RH
Remove the 5 bolts and engine under cover RH.
2.
REMOVE DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner
arm clockwise, and remove the drive belt.
F08868
3.
DISCONNECT SUCTION HOSE
Remove the clip and disconnect the suction hose.
NOTICE:
Take care not to spill fluid on the drive belt.
4.
DISCONNECT PRESSURE FEED TUBE
(a)
Using SST, disconnect the pressure feed tube.
SST
(b)
Remove the bolt and disconnect the pressure feed tube
clamp.
F13068
5.
DISCONNECT OIL PRESSURE SWITCH CONNECTOR
6.
REMOVE PS VANE PUMP ASSEMBLY
Remove the 2 pump assembly set bolts, nuts and PS vane
pump assembly.
09023–12700
SR0YP–02