Toyota AVENSIS 2000 Supplement Manual page 731

BO–8
: 4 Clips
AVENSIS/CORONA SUP (RM781E)
BODY – INSTRUMENT PANEL
REMOVAL
1. REMOVE FRONT DOOR OPENING TRIMS
2. REMOVE FRONT PILLAR GARNISHES
(a) w/ Curtain Shield Airbag:
(1) Remove the 2 bolts.
(2) Pack the airbag with protection cover.
(3) Using a screwdriver, raise the pillar garnish cover.
(4) Remove the bolt, pillar garnish cover and front pillar
garnish.
NOTICE:
Protection rang is from instrument panel to ceiling.
(b) Remove the front door scuff plates.
I12491
(c) Remove the cowl side trims.
(d) Remove the rear door opening trims.
(e) Remove the rear door scuff plates.
(f) Remove the center pillar lower covers.
(g) Remove the front seats.
3. REMOVE STEERING WHEEL (See page SR–6)
4. REMOVE LOWER FINISH PANEL
(a) Remove the 2 screws and hood lock control lever.
(b) Remove the 2 screws and lower finish panel.
5. REMOVE COLUMN COVER (See page SR–6)
6. REMOVE COMBINATION SWITCH (See page
SR–6)
7. REMOVE STEERING COLUMN (See page SR–6)
H03659
8. REMOVE CLUSTER FINISH PANEL
(a) Remove the 2 screws.
(b) Using a screwdriver, remove the cluster finish panel, then
disconnect the connector.
HINT:
Tape the screwdriver tip before use.
9. REMOVE COMBINATION METER
H03660
BO3VQ–01