MX–12
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (C50, C250)
7.
(a)
D07395
(b)
NOTICE:
At the time of reassembly, please refer to the following
item.
When fixing the lever lock pin, properly position the shaft
groove.
(c)
NOTICE:
D07396
At the time of reassembly, please refer to the following
items.
8.
(a)
(b)
D09357
(c)
–
MANUAL TRANSAXLE ASSEMBLY
REMOVE CONTROL SHIFT LEVER AND DUST BOOT
Remove the nut and wave washer.
Torque: 12 N·m (120 kgf·cm, 9 ft·lbf)
Using a pin punch and hammer, drive out the lever lock
pin.
Remove the control shift lever and dust boot.
S
Install the dust boot into a groove in the control shift
lever.
S
Be sure to install the dust boot in the correct direc-
tion, as shown in the illustration.
REMOVE PLUG, LOCK BALL ASSEMBLY AND CON-
TROL SHAFT COVER ASSEMBLY
Using a hexagon wrench, remove the plug and gasket.
Torque: 39 N·m (400 kgf·cm, 29 ft·lbf)
Remove the lock ball assembly.
Sealant:
Part No. 08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
Remove the 4 bolts and control shaft cover assembly with
the gasket.
Sealant:
Part No. 08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 20 N·m (200 kgf·cm, 14 ft·lbf)