Toyota AVENSIS 2000 Supplement Manual page 476

A
A
C
E
D
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (E351)
(d) Remove the 2 hole plugs and hole cover.
(e) Remove the 7 bolts and center member.
B
Torque:
Bolt A: 73 N·m (740 kgf·cm, 54 ft·lbf)
A
Bolt B: 52 N·m (540 kgf·cm, 38 ft·lbf)
21. JACK UP TRANSAXLE SLIGHTLY
Using a transmission jack, support the transaxle.
D06630
22. REMOVE ENGINE REAR MOUNTING BRACKET
Remove the 4 bolts and bracket.
Torque:
Bolt A: 98 N·m (1,000 kgf·cm, 72 ft·lbf)
Bolt B: 64 N·m (650 kgf·cm, 47 ft·lbf)
B
D02167
23. REMOVE ENGINE FRONT MOUNT AND MOUNTING
BRACKET
(a) Remove the bolt and nut.
Torque: 87 N·m (890 kgf·cm, 64 ft·lbf)
(b) Remove the 2 bolts.
Torque: 64 N·m (650 kgf·cm, 47 ft·lbf)
D06635
24. REMOVE TRANSAXLE LOWER SIDE MOUNTING
BOLT
Remove the 5 bolts.
A
Torque:
Bolt A: 40 N·m (408 kgf·cm, 30 ft·lbf)
B
Bolt B: 40 N·m (408 kgf·cm, 30 ft·lbf)
Bolt C: 8.0 N·m (82 kgf·cm, 71 in.·lbf)
Bolt D: 20 N·m (204 kgf·cm, 15 ft·lbf)
Bolt E: 46 N·m (470 kgf·cm, 34 ft·lbf)
D06637
25. REMOVE TRANSAXLE
Lower engine left side and remove the transaxle from the en-
gine.
HINT:
At the time of installation, please refer to the following items.
S
Align the input shaft with the clutch disc and install the
transaxle to the engine.
S
Temporarily tighten the transaxle mounting bolts.
26. REMOVE TRANSAXLE CASE PROTECTOR
Remove the 2 bolts and protector.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
– MANUAL TRANSAXLE UNIT
MX–7