Toyota AVENSIS 2000 Supplement Manual page 297

DI–166
Ts Terminal Circuit
CIRCUIT DESCRIPTION
The sensor check circuit detects abnormalities in the speed sensor signal which cannot be detected with
the DTC check.
Connecting terminals Ts and CG of the DLC3 on the lower finish panel starts the check.
WIRING DIAGRAM
W–B
A
J1 (LHD)
J/C
J27 (RHD)
II (LHD)
IJ (RHD)
INSPECTION PROCEDURE
1 Check voltage between terminals Ts and CG of DLC3.
Ts
DLC3
CG
NG
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
DLC3
CG Ts
4 14
F04969
– ANTI–LOCK BRAKE SYSTEM WITH ELECTRONIC
BRAKE FORCE DISTRIBUTION (EBD)
R–B
CHECK:
(a) Turn the ignition switch ON.
(b) Measure voltage between terminals Ts and CG of DLC3.
OK:
Voltage: 5.7 – 8.1 V
OK If ABS warning light does not blink even after Ts
and CG are connected, the ECU may be defec-
tive.
DI7Z9–01
ABS ECU with
Actuator
11
A6 Ts
F04477