Toyota AVENSIS 2000 Supplement Manual page 376

INSPECTION PROCEDURE
HINT:
Start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not
using the hand–held tester.
1 Check operation of the VSC OFF indicator light.
PREPARATION:
(a) Connect the hand–held tester to the DLC3.
(b) Turn the ignition switch ON and push the hand–held tester main switch ON.
(c) Select the ACTIVE TEST mode on the hand–held tester.
CHECK:
Check that "ON" and "OFF" of the VSC OFF indicator light can be shown on the combination meter with the
hand–held tester.
OK
2 Check VSC OFF switch.
4
(+)
OK
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
PREPARATION:
(a)
1
(b)
CHECK:
Measure the resistance between terminals 1 and 4 of the VSC
OFF switch when the VSC OFF switch is ON and OFF.
OK:
(–)
F00052
– ABS WITH EBD & BA & TRC & VSC SYSTEM
NG Go to step 4.
Remove the VSC OFF switch.
Disconnect the VSC OFF switch connector.
VSC OFF switch
Pressed
Released
NG Replace VSC OFF switch.
DI–245
Resistance
Continuity
1MΩ or higher