Toyota AVENSIS 2000 Supplement Manual page 578

Shift Lever
Sub–assembly
A
Detent Rod
Grooved Pin
A00452
: Apply MP Grease
AVENSIS/CORONA SUP (RM781E)
AUTOMATIC TRANSAXLE (A246E)
(f)
NOTICE:
When pressing in the grooved pin, if doing it at the place
other than the notch, the shift lever sub–assembly might be
damaged.
4.
F01188
5.
Drive the shift lever knob sleeve to the distance A measured be-
fore removal.
A
D04313
6.
(a)
F00690
(b)
NOTICE:
Take care not to install them in the wrong direction of the
shift lever sub–assembly.
7.
F00691
8.
Install the shift control control computer and 2 screws.
NOTICE:
Install the grooved pin into the groove of the shift lock unit
as shown in the illustration.
F00692
– FLOOR SHIFT ASSEMBLY (LHD)
Press the pin with a hammer.
A: 10.0 – 10.4 mm (0.39 – 0.41 in.)
CHECK DETENT ROD OPERATION
INSTALL SHIFT LEVER KNOB SLEEVE DETENT ROD
INSTALL SHIFT LEVER SUB–ASSEMBLY
Apply MP grease.
Using a brass bar and a hammer, install the control shaft
and the shift lever sub–assembly to the shift lever plate.
INSTALL SPRING PLATE
INSTALL SHIFT LOCK CONTROL COMPUTER
AX–17