Table of Contents
Advertisement
DI–232
INSPECTION PROCEDURE
HINT:
Start the inspection from step 1 in case of using a hand–held tester and start from step 2 in case of not using
the hand–held tester.
1
Check operation of the ABS warning light.
PREPARATION:
(a)
Connect the hand–held tester to the DLC3.
(b)
Turn the ignition switch ON and push the hand–held tester main switch ON.
(c)
Select the ACTIVE TEST mode on the hand–held tester.
CHECK:
Check that "ON" and "OFF" of the ABS warning light can be shown on the combination meter on the hand–
held tester.
NG
2
Check ABS warning light.
See combination meter troubleshooting (See Pub. No. RM599E on page BE–57).
OK
Repair or replace and check for open or short circuit in harness and connector.
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
–
ABS WITH EBD & BA & TRC & VSC SYSTEM
OK
Check and replace ABS & BA & TRC & VSC
ECU with actuator assembly.
NG
Replace or repair bulb or combination meter.
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
