MX–16
SST
SST
SST
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (S54, S55)
INSPECTION
1.
(a)
(b)
If the braking effect is insufficient, replace the synchronizer ring.
MT0782
2.
Using a feeler gauge, measure the clearance between the hub
sleeve and shift fork.
If the clearance exceeds the maximum, replace the shift fork or
hub sleeve.
WM0066
3.
(a)
SST
(b)
Z00409
(c)
(d)
SST
Z00410
4.
(a)
SST
(b)
Z00411
–
MANUAL TRANSAXLE ASSEMBLY
INSPECT NO.5 SYNCHRONIZER RING
Check wear or damage.
Check the braking effect of the synchronizer ring turn the
middle No.5 synchronizer ring in one direction while push-
ing it to the outer No.5 synchronizer ring. Check that the
ring locks.
INSPECT NO.3 SHIFT FORK AND NO.3 HUB SLEEVE
CLEARANCE
Maximum clearance: 0.4 mm (0.0157 in.)
IF NECESSARY, REPLACE INPUT SHAFT FRONT
BEARING
Remove the 2 bolts and transaxle case receiver.
Using SST, pull out the bearing.
SST
09308–00010
Using SST and a press in a new bearing.
SST
09310–35010
Install the transaxle case receiver and torque the 2 bolts.
Torque: 7.4 N·m (75 kgf·cm, 65 in.·lbf)
IF NECESSARY, REPLACE OUTPUT SHAFT FRONT
BEARING
Remove the bolt and bearing lock plate.
Using SST, pull out the bearing.
SST
09308–00010
MX06P–02