Toyota AVENSIS 2000 Supplement Manual page 672

Inscribed Mark
Inscribed Mark
Inscribed Mark
AVENSIS/CORONA SUP (RM781E)
STEERING
F08475
F08476
Compressed Air
F08804
F08478
– POWER STEERING VANE PUMP (1ZZ–FE, 3ZZ–FE)
If it is more than the maximum, replace the vane plate and/or
vane pump rotor with the one having the same mark stamped
on the cam ring.
Inscribed mark: 0, 1, 2, 3, or 4
HINT:
There are 5 vane plate lengths corresponding to the following
vane pump rotor and cam ring marks:
Vane pump rotor and
cam ring mark
0
1
2
3
4
3. INSPECT FLOW CONTROL VALVE
(a) Coat the flow control valve with power steering fluid and
check that it falls smoothly into the valve hole of the front
housing by its own weight.
(b) Check the flow control valve for leakage. Close one of the
holes and apply compressed air of 392 – 490 kPa (4 – 5
2
kgf/cm , 57 – 71 psi) into the opposite side hole, and con-
firm that air does not come out from the end hole.
If necessary, replace the flow control valve with the one having
the same letter as inscribed on the front housing.
Inscribed mark: A, B, C, D, E or F
Vane plate part Vane plate length
number
12.001 – 12.003
44345 – 02110
(0.47248 – 0.47256)
11.999 – 12.001
44345 – 02120
(0.47240 – 0.47248)
11.997 – 11.999
44345 – 02130
(0.47232 – 0.47240)
11.995 – 11.997
44345 – 02140
(0.47224 – 0.47232)
11.993 – 11.995
44345 – 02150
(0.47216 – 0.47224)
SR–13
mm (in.)