MX–16
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (E351)
24.
Using a hexagon wrench (6 mm), remove the 2 plugs.
D09368
25.
26.
Pull up the No.3 shift fork shaft, remove the No.1 shift fork shaft.
HINT:
At the time of reassembly, please refer to the following item.
When it is difficult to push the fork shaft through the reverse shift
fork, pull up the No.3 shift fork shaft.
Q08124
27.
Using a magnetic finger, remove the interlock roller from the re-
verse shift fork.
Q08125
28.
(a)
(b)
Q08126
29.
(a)
(b)
30.
(a)
(b)
Z00182
–
MANUAL TRANSAXLE ASSEMBLY
REMOVE STRAIGHT SCREW PLUG
Sealant:
Part No. 08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
REMOVE NO.1, NO.2 SHIFT FORKS AND SHIFT HEAD
SET BOLT
Torque: 24 N·m (240 kgf·cm, 17 ft·lbf)
REMOVE NO.1 SHIFT FORK SHAFT
REMOVE INTERLOCK ROLLER
REMOVE NO.2 SHIFT FORK SHAFT, SHIFT HEAD
AND NO.1 SHIFT FORK
Pull out the No.2 shift fork shaft.
Remove the shift head and No.1 shift fork.
REMOVE NO.3 SHIFT FORK SHAFT WITH REVERSE
SHIFT FORK AND NO.2 SHIFT FORK
Pull out the No.3 shift fork shaft with the reverse shift fork.
Remove the No.2 shift fork.
REMOVE SNAP RING
Using 2 screwdrivers and a hammer, remove the snap
ring and reverse shift fork from the No.3 shift fork shaft.
Using 2 screwdrivers and a hammer, remove the 3 snap
rings from the No.1, No.2 and No.3 shift fork shafts.