Toyota AVENSIS 2000 Supplement Manual page 7

IN–2
The procedures are presented in a step–by–step format:
S
The illustration shows what to do and where to do it.
S
The task heading tells what to do.
S
The detailed text tells how to perform the task and gives other information such as specifications
and warnings.
Example
Illustration:
what to do and where
This format provides the experienced technician with a FAST TRACK to the information needed. The upper
case task heading can be read at a glance when necessary, and the text below it provides detailed informa-
tion. Important specifications and warnings always stand out in bold type.
6. REFERENCES
References have been kept to a minimum. However, when they are required you are given the page to refer
to.
7. SPECIFICATIONS
Specifications are presented in bold type throughout the text where needed. You never have to leave the
procedure to look up your specifications. They are also found in Service Specifications section for quick ref-
erence.
8. CAUTIONS, NOTICES, HINTS:
S
CAUTIONS are presented in bold type, and indicate there is a possibility of injury to you or other
people.
S
NOTICES are also presented in bold type, and indicate the possibility of damage to the components
being repaired.
S
HINTS are separated from the text but do not appear in bold. They provide additional information to
help you perform the repair efficiently.
9. SI UNIT
The UNITS given in this manual are primarily expressed according to the SI UNIT (International System of
Unit), and alternately expressed in the metric system and in the English System.
Example:
Torque: 30 N·m (310 kgf·cm, 22 ft·lbf)
AVENSIS/CORONA SUP (RM781E)
INTRODUCTION – HOW TO USE THIS MANUAL
21. CHECK PISTON STROKE OF OVERDRIVE BRAKE
(a) Place SST and a dial indicator onto the overdrive brake pis-
ton as shown in the illustration.
SST 09350–30020 (09350–06120)
Set part No.
Detailed text :
(b) Measure the stroke applying and releasing the compressed
785 kPa, 4
air (392
in the illustration.
Piston stroke: 1.40
Task heading : what to do
Component part No.
how to do task
8 kgf/cm 2
or 57 114 psi) as shown
0.0669 in.)
1.70 mm (0.0551
Specification