Toyota AVENSIS 2000 Supplement Manual page 189

DI–58
INSPECTION PROCEDURE
1 Check KICK DOWN SW signal.
ON
(–)
NG
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS
KD
(+)
D07200
– AUTOMATIC TRANSAXLE (A246E)
When using hand–held tester:
PREPARATION:
(a) Remove the DLC3 cover.
(b) Connect a hand–held tester to the DLC3.
(c) Turn the ignition switch ON and hand–held tester main
switch ON.
CHECK:
Read the KICK DOWN SW signal on the hand–held tester.
OK:
Accelerator Pedal
Fully depressed (kick–down SW is ON)
Released (kick–down SW is OFF)
When not using hand–held tester:
PREPARATION:
Turn the ignition switch ON.
CHECK:
Measure voltage between terminal KD of Engine and ECT ECU
connector and body ground when accelerator pedal is fully de-
pressed or not.
OK:
Accelerator Pedal
Fully depressed (kick–down SW is on)
Released (kick–down SW is OFF)
OK Proceed to next circuit inspection shown in
problem symptoms table (See page DI–18).
KICK DOWN
SW signal
ON
OFF
Voltage
Below 1 V
10 – 14 V