Toyota AVENSIS 2000 Supplement Manual page 530

SST
x 6
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (S54, S55)
HINT:
At the time of reassembly, please refer to the following item.
Using SST and a press, install the No.3 clutch hub assembly.
(c)
15.
Q02682
16.
x 5
Remove the 5 bolts and retainer.
17.
Using a snap ring expander, remove the 2 snap rings.
HINT:
Q05785
If it is difficult to remove and install the snap rings, pull up the
shafts.
18.
19.
x 17
Remove the 6 bolts, retainer and shim.
Q05826
20.
(a)
(b)
FIPG
Q09474
– MANUAL TRANSAXLE ASSEMBLY
SST 09612–22011
Remove the 5th gear.
REMOVE NEEDLE ROLLER BEARING
REMOVE REAR BEARING RETAINER
Sealant:
Part No.08833–00070, THREE BOND 1324 or equiva-
lent
Torque: 42 N·m (430 kgf·cm, 31 ft·lbf)
REMOVE SNAP RING
REMOVE REVERSE IDLER GEAR SHAFT LOCK BOLT
AND GASKET
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
REMOVE DIFFERENTIAL SIDE BEARING RETAINER
AND SHIM
Sealant:
Part No.08833–00080, THREE BOND 1344, LOCTITE
242 or equivalent
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
REMOVE TRANSMISSION CASE
Remove the 17 bolts.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
Using a plastic hammer, tap the transmission case and re-
move it.
FIPG:
Part No. 08833–00090, THREE BOND 1281 or equiva-
lent
MX–13