Toyota AVENSIS 2000 Supplement Manual page 643

SA–6
SST
AVENSIS/CORONA SUP (RM781E)
SUSPENSION AND AXLE –
6. REMOVE DYNAMIC DAMPER
(a) Using a side cutter, cut the dynamic damper clamp and re-
move it.
(b) Remove the dynamic damper.
7. REMOVE OUTBOARD JOINT BOOT
NOTICE:
Do not disassemble the outboard joint.
8. REMOVE DUST COVER
(a) RH drive shaft of 3ZZ–FE engine and LH drive shaft:
SST
Using SST and a press, remove the dust cover from the
inboard joint shaft.
SST
R09716
(b) RH drive shaft of 1ZZ–FE and 1AZ–FSE engine:
Using a press, remove the dust cover from the inboard
joint shaft.
SA1446
9. RH drive shaft of 1ZZ–FE and 1AZ–FSE engine:
DISASSEMBLE INBOARD JOINT SHAFT
(a) Using a screwdriver, remove the snap ring.
(b) Using a press, remove the bearing case.
(c) Using a pin punch and hammer, remove the straight pin
from the bearing case.
Z18045
(d) Using SST and a press, remove the dust cover.
SST
(e) Using a snap ring expander, remove the snap ring.
Z18046
FRONT DRIVE SHAFT
09950–00020
09950–00020