Toyota AVENSIS 2000 Supplement Manual page 166

INSPECTION PROCEDURE
1 Measure resistance between terminal SL of Engine and ECT ECU and body
ground.
SL
NG
2 Check harness and connector between Engine and ECT ECU and automatic
transaxle solenoid connector.
SL
OK
AVENSIS/CORONA SUP (RM781E)
DIAGNOSTICS –
PREPARATION:
Disconnect the connector from Engine and ECT ECU.
CHECK:
Measure resistance between the terminal SL of Engine and
ECT ECU and the body ground.
OK:
Resistance: 11 – 15 Ω
D07195
OK
PREPARATION:
Disconnect the solenoid connector from the transaxle.
CHECK:
Check the harness and connector between the terminal SL of
Engine and ECT ECU and the terminal 2 of solenoid connector.
OK:
There is no open or short circuit.
2
D07196
NG
AUTOMATIC TRANSAXLE (A246E)
Check and replace the E
(See page IN–30).
Repair or replace the harness or connector.
DI–35
ngine and ECT ECU