Toyota AVENSIS 2000 Supplement Manual page 460

SST
SST
AVENSIS/CORONA SUP (RM781E)
MANUAL TRANSAXLE (C50, C250)
DISASSEMBLY
1.
(a)
Matchmarks
(b)
(c)
D00855
2.
(a)
HINT:
Set the claw of SST to the bearing inner race at the position
where the speed sensor drive gear is indented.
Z16131
(b)
3.
Using SST, remove the side bearing.
HINT:
Set the claw of SST to the bearing inner race at the position
where the differential case is indented.
Q07848
4.
Using a dial indicator, measure the backlash of one side gear
while holding one pinion toward the case.
If the backlash is not within the specification, install the correct
thrust washer to the side gears.
5.
(a)
Q00807
(b)
(c)
– DIFFERENTIAL CASE
REMOVE RING GEAR
Place matchmarks on the ring gear and case.
Remove the 8 bolts.
Using a copper hammer, tap on the ring gear to remove
it from the case.
Speed Sensor Drive Gear Side:
REMOVE SIDE BEARING FROM DIFFERENTIAL
CASE
Using SST, remove the side bearing.
SST 09950–00020, 09950–00030, 09950–60010
(09951–00360)
Remove the speed sensor drive gear.
Ring Gear Side:
REMOVE SIDE BEARING FROM DIFFERENTIAL
CASE
SST 09950–00020, 09950–00030, 09950–60010
(09951–00360)
INSPECT SIDE GEAR BACKLASH
Standard backlash:
0.05 – 0.20 mm (0.0020 – 0.0079 in.)
DISASSEMBLE DIFFERENTIAL CASE
Using a pin punch and hammer, drive out the straight pin.
Remove the pinion shaft from the case.
Remove the 2 pinions and side gears with the 4 thrust
washers from each gear.
MX–39
MX00K–03