Toyota AVENSIS 2000 Supplement Manual page 704

INSPECTION
1. INSPECT DOUBLE LOCKING SYSTEM FUNCTION
HINT:
S
In case of doing the following inspection, must open one of the windows of the doors.
S
To set the double lock, turn the ignition switch OFF, pull out the key, open the driver's door and then
perform the lock operation on the wireless transmitter. Locking again within 5 sec, after the first locking
sets the double lock.
(a) Check that the double lock is set.
(1) With the glass window opened, set the double lock from the outside of a vehicle using a wireless
transmitter.
(2) Check that the doors won't open from the inside of the vehicle even operating the door lock knob
and inside door handle
(b) Check that the double lock is released (Case 1).
(1) Press the UNLOCK button on the wireless transmitter.
(2) Check that the doors will open from the inside of the vehicle by operating the door knob and inside
door handle.
(c) Check that the double lock is released (Case 2).
(1) With the glass window opened, set the double lock from the outside of a vehicle using a wireless
transmitter.
(2) Under this condition, insert the key into the ignition key cylinder, turn the ignition switch to ON
and check that the doors will open.
If you find any abnormal symptom in the check items of (a),(b) and (c), troubleshoot according to the Problem
Symptom Table.
AVENSIS/CORONA SUP (RM781E)
BODY ELECTRICAL – DOUBLE LOCKING SYSTEM
2. INSPECT DRIVER'S DOUBLE LOCKING SWITCH
CONTINUITY
Switch position
OFF (Double Locking is
released)
ON (Double Locking is
set)
If continuity is not as specified, replace the door lock assembly.
3. INSPECT DRIVER'S DOUBLE LOCKING MOTOR OP-
I19379
ERATION
(a) Set the Door Lock to LOCK position by the locking cable.
(b) Connect the positive (+) lead from the battery to terminal
7 and negative (–) lead to terminal 8, and check that the
Door Lock will not unlock by pulling the locking cable.
(c) Reverse the polarity and check that the Door Lock will un-
lock by pulling the locking cable.
If operation is not as specified, replace the door lock assembly.
Tester connection Specified condition
– No continuity
9 – 1 Continuity
BE–13
BE1XR–01