Table of Contents
Advertisement
16
Ignition Coil and Flywheel
1
6
530
Figure 16-8 Crankcase Cover Installation
IGNITION COIL AND FLYWHEEL
See General Warning on page 1-1.
IGNITION COIL AND FLYWHEEL REMOVAL
1.
Loosen three screws (2) and remove the remaining four screws (1) attaching the flywheel housing as shown,
then remove the housing (Figure 16-9, Page 16-8).
2.
Disconnect the ignition coil (11) from its primary lead wire at the connector (12). Remove the two bolts (10) and
take out the ignition coil (Figure 16-10, Page 16-8).
1
531
Figure 16-9 Flywheel Housing
3.
Hold the flywheel (4), not the fan (7), with a strap wrench (5) and, using a 25 mm socket, remove the flywheel nut
(and flat washer) by turning it counterclockwise (Figure 16-11, Page 16-9). See following CAUTION.
Page 16-8
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
7
2
4
13
1
11
510
S27 FE 350 ENGINE
12
Figure 16-10 Ignition Coil
10
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
