Solenoid Installation; Onboard Computer (Obc); Onboard Computer Removal - Club Car Turf 252 2007 Maintenance And Service Manual

24

Onboard Computer (OBC)

1
Figure 24-7 Solenoid

SOLENOID INSTALLATION

1. Mount solenoid (2) onto component mounting plate with screws (1) (Figure 24-7, Page 24-10).
2. Tighten screws (1) to 60 in-lb (6.8 N·m).
3. Using the wiring diagram, install the wires, washers, and nuts onto the large mounting posts. Tighten nuts to 77
in-lb (8.7 N·m). See Wiring Diagrams, Section 22, Page 22-2.
4. Install the blue/white and light blue wires onto the small terminals of the solenoid (Figure 24-7, Page 24-10).
5. Install speed controller cover. See See Installing the Speed Controller Cover on page 24-8.
6. Connect the batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
ONBOARD COMPUTER (OBC)
See General Warning on page 1-1.
TESTING THE ONBOARD COMPUTER
See Test Procedure 2 – Onboard Computer Solenoid Lockout Circuit on page 22-11, Test Procedure 21 –
Onboard Computer Silicon-Controlled Rectifier (SCR) Circuit on page 22-29 and Test Procedure 22 – Onboard
Computer Gray Wire and Fuse on page 22-29.

ONBOARD COMPUTER REMOVAL

1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Remove speed controller cover. See Removing the Speed Controller Cover on page 24-8.
3. Unplug the six-pin connector (1) at the OBC (Figure 24-8, Page 24-11).
Page 24-10 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: ELEC-
TRIC VEHICLES