Table of Contents
Advertisement
14
Voltage Limiter
HEADLIGHT BULB INSTALLATION
NOTE: When handling halogen bulbs, do not touch glass portion of bulb. Oil from finger tips can cause premature
failure of bulb.
1.
Connect wire harness (4) to the halogen bulb assembly (6). The retaining tab should lock onto the halogen bulb
assembly (Figure 14-31, Page 14-29).
2.
From the front of vehicle, reach under cowl and insert wire harness/halogen bulb assembly (4 and 6), into the
headlight lens (7).
3.
Turn the wire harness/halogen bulb assembly (4 and 6) counterclockwise one-quarter turn.
4.
Connect battery. See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
VOLTAGE LIMITER
See General Warning on page 1-1.
TESTING THE VOLTAGE LIMITER
See Test Procedure 29 – Voltage Limiter on page 12-40.
VOLTAGE LIMITER REMOVAL
1.
Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
2.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-3.
3.
Remove the instrument panel. See Key Switch Removal on page 14-13.
4.
Disconnect wires from the voltage limiter (1). Do not allow wires to touch (Figure 14-32, Page 14-31).
NOTE: Identify terminal for solid black wire and terminal for black/white wire.
5.
Remove the mounting hardware (2) from the voltage limiter and remove it from the vehicle.
VOLTAGE LIMITER INSTALLATION
1.
Mount the voltage limiter to the frame using the mounting hardware and tighten to 25 in-lb (2.8 N·m) (Figure
14-32, Page 14-31).
2.
Connect the black/white wire from harness to the negative (–) terminal on the diode.
3.
Connect the solid black wire from the ground terminal block to the positive (+) terminal on the diode.
4.
Install the dash panel in reverse order of removal. See Key Switch Removal on page 14-13.
5.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
Page 14-30
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
ELECTRICAL COMPONENTS: PEDAL-
START GAS VEHICLE
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
