Fuel Filter Installation - Club Car Turf 252 2007 Maintenance And Service Manual

S10 FE 350 FUEL SYSTEM
4. Remove the primary fuel filter (17) (Figure 17-13, Page 17-18).
4.1. Remove the clamps (16) and fuel lines (1 and 2) from the filter and plug the fuel lines.
5. Remove the secondary filter (22), if equipped.
5.1. Remove the clamps (16) and fuel lines (3 and 4) from the filter and plug the fuel lines (3 and 4).

FUEL FILTER INSTALLATION

CAUTION
• Fuel filters are marked with flow direction arrows. Make sure that filters are installed with arrows
pointing in the direction of fuel flow from tank to carburetor.
1. Install the primary fuel filter (17) in the fuel line. Use new clamps (16) (Figure 17-13, Page 17-18).
2. If equipped, install the secondary fuel filter (22) in the fuel line. Use new clamps (16).
3. Turn the fuel shut-off valve to the ON position (Figure 17-18, Page 17-26 or Figure 17-19, Page 17-26).
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
5. XRT 900: Place the Forward/Reverse handle in the NEUTRAL position and chock the wheels. See following
DANGER.
6. Turf/Carryall 252: Place the Forward/Reverse handle in the NEUTRAL position, chock the wheels, and the
neutral lockout switch in the MAINTENANCE position. See following DANGER.
DANGER
• Repair all fuel leaks before operating the vehicle.
7. Start the engine and check for fuel leaks.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
17
Fuel Filters
Page 17-17