Table of Contents
Advertisement
13
Key Switch
2
502
Figure 13-18 Key Switch Removal
KEY SWITCH INSTALLATION
1.
Reverse removal procedures to install key switch in the dash. Connect wires to key switch. See Wiring Diagrams
on page 11-7. Coat the connectors with Battery Terminal Protector Spray (CCI P/N 1014305) to prevent corrosion.
Be sure that key switch terminals cannot touch the frame and that panel is properly seated and snapped in place.
2.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
Page 13-18
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
1
ELECTRICAL COMPONENTS: KEY-START WITH
NEUTRAL REV GAS VEHICLE
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
